Getting started with Pison PERFORM
Get Started in 8 Easy Steps
1. Unbox and remove plastic covers
Unbox your wearable and charging cable. Remove the plastic film from the front screen and sensor array on the back of your wearable.

2. Charge your wearable
Plug the USB end of the included Charging Cable into a power source (laptop or USB adaptor, not included). Then attach the magnetic clip to the charging port. To get started, charge your wearable to at least 20%. You can complete steps 3-6 while your wearable is charging.
3. Download the Pison app
Select your platform, Apple or Google.
Open the app and, when prompted, allow the app to find nearby devices.
4. Log in
Log in using your membership email and password.
5. Pair your wearable
In the app, select Find Device. In the list, find the wearable with the matching Serial Number (SN) and select it to start pairing.
Refer to the Wearable Menu Overview below to locate the Serial Number (SN).

6. Update wearable firmware
If prompted to update your wearable’s firmware, follow the on-screen instructions and press Update.
7. Put on your wearable
The wearable is worn like a wristwatch:
- loosen the strap.
- slide your hand through the strap.
- Place the wearable on the outside of your wrist, just above the wrist bone.
- Tighten the strap so the wearable fits snugly against your skin without moving.
Note: Consistent skin contact is important for accurate measurements.

8. Measure your cognitive performance
Visit the link here to start your cognitive measurements and finish setting up your wearable.